The Nuraphone Gaming Microphone is a separately sold accessory that enables voice chat over a 3.5mm analog connection.
![]() |
|
Using the Nuraphone Gaming Microphone:
First, make sure your Nuraphones are up to date with the latest firmware. Please view this article for further instructions: Updating your Nuraphones
Attach the Nuraphone connector end of the Gaming Microphone to the Nuraphone cable port.
![]() |
![]() |
![]() |
Place hook over cup rim. | Slide hook forward until cable is secured. |
Proceed to slide the Secure Hook forward, which will lock the Gaming Microphone into place. You should hear a ‘click’ once the Hook is secured.
Ensure to slide the Secure Hook off prior to removing the Gaming Microphone.
You can easily store the Secure Hook on the Nuraphones by rotating the Secure Hook so that it latches onto the cup cable. | ![]() |
1. Volume Control Move the Volume Control dial up to increase the input volume up, or down to decrease the input volume. 2. Mute Control Move the slider down to activate the mute control and then move it up to resume using the microphone. |
![]() |
Use the 3.5mm analog connector and connect this into the headphone port of the controller. To adjust the Microphone input level refer to your devices manual / user guide.
In order to connect the Nuraphone Gaming Microphone to a PC or Mac, your computer must have a single headphone port that can also accept a microphone signal (or 4-pin TRRS input).
If your computer does have an integrated headphone / microphone 3.5mm port:
Please connect the Nuraphone Gaming Microphone to the headphone port and ensure that the on-board headphone/microphone signal is selected within your computer’s settings.
If your computer does not have a combined port:
Check whether your computer has separate ports, such as those two ports listed below:
![]() |
|||
Headphone / Output port |
Microphone / Input port |
In this instance, you'll need to look at using a 3.5 mm Stereo Audio Splitter (1 Female to 2 Male) Adapter Cable in order to connect the Nuraphone Gaming Microphone to your computer.
While Nura does not produce this cable, we can recommend the following cable options if you do not already have one:
- 3.5mm Y Splitter Audio Cable (1 Female to 2 Male) Black - Amazon Listing
- MillSO 3.5mm Y Splitter Audio Cable (1 Female to 2 Male) - Amazon Listing
To connect the Nuraphone Gaming Microphone to a third-party adapter, please follow the diagram below:

- Headphone/Output port
- Microphone/Output port
- Third party 3.5mm Y Splitter (1 Female to 2 Male)*
- Nuraphone Gaming Microphone 3.5mm Jack (4-pin TRRS)
First connect the Nuraphone Gaming Microphone jack into the female jack of the third-party 3.5mm Y Splitter, then connect both the headphone and microphone jacks to their corresponding ports on your computer. Once you have connected this, ensure that your computer has selected the onboard headphone/microphone ports as the corresponding input and output.
If you are unsure of how to check or change those system settings, refer to your computer’s manufacturer’s user documentation.
*Sold Separately
First disconnect the Nuraphone Gaming Microphone from your Nuraphone and then use either the TouchButtons or connect to the Nura app to switch between Social Mode, Active Noise Cancellation (ANC) or other settings.
IMPORTANT: The TouchButtons do not operate when the Nuraphone is connected via a cable.
Need more information?
Check out either our Frequently Asked Questions or Troubleshooting articles.